Attributes
- Leveringsvekt: 0,045kg
- Frakthøyde: 13mm
- Fraktbredde: 76mm
- Fraktlengde: 254mm
- UPC: 050806023253
Produktnr.: 587036968
Produsentnr.: 36968
050806023253 Opprinnelig designet for metallarbeidere og mekanikere for å fjerne fastsittende bolter, disse kraftige ekstraktorene biter seg fast i metallet for ekstra grep, slik at du kan påføre kraften som trengs for å fjerne en choke som nekter å gi etter for vanlige verktøy. Tilgjengelig for 12 og 20 gauge. Fullstendige instruksjoner inkludert. Advarsel: munnskade kan oppstå hvis den brukes feil.Restordre. Sendes når kommer til lager. Leveringstid ca 4-12 uker fra USA lager.
Opprinnelig designet for metallarbeidere og mekanikere for å fjerne fastklemte bolter, disse robuste ekstraktorene biter seg fast i metallet for ekstra grep, slik at du kan påføre den nødvendige kraften for å fjerne en choke som nekter å løsne med vanlige verktøy. Tilgjengelig for 12 og 20 gauge. Komplette instruksjoner følger med. Advarsel: Munnskade kan oppstå hvis det brukes feil.
Didn't work 12.08.2014
I tried to remove a stuck choke tube from a Bennelli shotgun with no luck at all. I had previously talked with a Brownell's consultant and was told to follow the written instructions that came with the tool. I did that to the letter. The cutting edges of the tool were softer than the choke tube metal and merely broke away as I tried to twist the tool.
I finally had to try another method of removal which I found on Youtube. I used JB Weld to glue in a deep well socket that was about 1/8 of an inch smaller in diameter than the choke tube. After letting it set up for 24 hours I used a ratchet to remove the socket which bonded to the choke tube.
I would return the tool to Brownells except that postage would cost as much as the tool.
Worked well 02.04.2014
I had an inventor DS choke tube stuck in an A5 thats about a year old. Tried everything to get the choke out to the point where wrenches wore the notches on the tube.
I bought this tool as a hail mary before relenting and going to a gunsmith. It took a couple tries and tapping the tool in harder, but with a crescent wrench and a couple sharp raps with a hammer to the tool was finally able to get the tube out. No damage to barrel, choke was not any more messed than before, junking it though.
You might have drive the tool in a little harder than you think.
Good price shipping was good, fedex is always good.
Vi opplevde en feil under innlasting av dette innholdet. Vennligst last inn siden på nytt for å fortsette. Hvis problemet vedvarer, ta kontakt med kundeservice.