The Sinclair Bullet Seating Depth Tool has been used for decades by handloaders seeking the most accuracy out of their rifles. Our newest model is made from one fourth inch ground and polished stainless steel with one end turned down for use with 17 and 20 caliber rifles and the other end used for 22 caliber and up. This tool helps you determine the length of a loaded round touching the rifling. The Sinclair Seating Depth Tool will work with most bolt action, single shot and AR type rifles. The tool includes a Delrin action guide suitable for most bolt-action rifles (0.690” Diameter fits Remingtons, Savages, Winchesters, and many Rugers). For the most accurate measurement, the Sinclair Bullet Seating Depth Tool uses your fireformed brass and bullets so you can expect an exact measurement, every time. Also available are guides use in AR-15's, AR-10's, and Tubb's 2000's. The guide is a little different than our standard bolt-action guides. This guide inserts into the back of the upper receiver (with the bolt removed). The tool is then used as normal. For best results couple this tool with our Bullet Comparators and a good set of calipers to get repeatable and precise Base-To-Ogive measurements.
Oppdag presisjon med Sinclair Bullet Seating Depth Tool!
Sinclair Bullet Seating Depth Tool har vært brukt i flere tiår av håndladere som søker maksimal presisjon fra sine rifler. Vår nyeste modell er laget av en fjerdedels tomme grunnet og polert rustfritt stål, med den ene enden tilpasset bruk med 17 og 20 kaliber rifler, mens den andre enden er beregnet for 22 kaliber og oppover.
Funksjoner:
- Hjelper deg med å bestemme lengden på en ladd patron som berører riflingen.
- Kompatibel med de fleste bolt-action, single shot og AR-type rifler.
- Inkluderer en Delrin action guide som passer til de fleste bolt-action rifler (0.690” Diameter passer til Remingtons, Savages, Winchesters, og mange Rugers).
- Bruker ditt brannformede messing og kuler for nøyaktige målinger hver gang.
- Tilgjengelig med guider for AR-15, AR-10 og Tubb's 2000.
Guiden er litt annerledes enn våre standard bolt-action guider. Denne guiden settes inn i baksiden av den øvre mottakeren (med bolten fjernet). Verktøyet brukes deretter som normalt.
For best resultat, kombiner dette verktøyet med våre Bullet Comparators og et godt sett med kalipere for å få gjentakelige og presise Base-To-Ogive målinger.