Attributes
- Leveringsvekt: 0,023kg
- Frakthøyde: 8mm
- Fraktbredde: 62mm
- Fraktlengde: 166mm
Produktnr.: 310150002
Produsentnr.: NONE
Den berømte stokkmakeren Jerry Fisher sier: "I løpet av 20 år med stokkproduksjon har dette vært den beste innleggs-skraperen jeg noen gang har brukt, og jeg har prøvd noen. Bare hold den som en blyant og arbeid fra høyre til venstre, eller venstre til høyre, avhengig av retningen på treverket." Presisjonsbearbeidet fra hard legering verktøystål, skjerpet og klar til bruk. Instruksjoner inkludert. Tre verktøy, hver med to forskjellige størrelser på hodene. Målingene som er oppgitt, er størrelser på kuttehodet.
Gratis frakt fra kr 2 990.
Leveringstid ca. 14-21 dager.
Den berømte våpenmakeren Jerry Fisher sier: "I 20 år med våpenmaking er dette den beste innleggs-skraperen jeg noen gang har brukt, og jeg har prøvd noen. Bare hold den som en blyant og arbeid fra høyre til venstre, eller venstre til høyre, avhengig av retningen på treverket."
Produktbeskrivelse:
Presisjonsbearbeidet fra slitesterkt verktøystål, skarp og klar til bruk. Instruksjoner inkludert. Tre verktøy, hver med to forskjellige størrelser på hode. Målingene som er oppgitt er størrelser på kuttehodene.
Good Tool for Scraping any Flat Wood 11.12.2014
I have used Jerry Fisher scrapers for 30 years.
This flat scaper allows you to work any flat surface in the inletting. It ca also be used to clean up edge in places like a shadow line cheeck piece.
SPECTACULAR PRODUCT 12.03.2011
First ..I am a first time user and a first time maker of a fore end for a Schutzen fore end. I started out with a 3/4 " burr placed in a drill press to set the initial path of the burr . I found the that I would have to set the fore end piece in a drill press vice so that the wood would slide in the vice. I also the found that I even had to tip the piece to engage the burr into the wood (English Walnut) This at least, set the path for the beginning of the inletting for a tapered barrel. (swamped barrel) After taking a bounty paper towel (no interest...just love them )I was able to take the inletting black, also from Brownells (I think the gold would have been too light ..I am 70 years old so....)Coating the barrel with the black and the spinning it into the the new started barrel grouve I found that this scraper while just removing the highlighted black area ...many many times produced a barrel grouve inlett that was not only perfect but put my inlet actually a little low, Perfect, now I could sand or scrape off to make the top surface perfect with the appropriate depth. This was great because I lost control of the tool (my error) the top surface was then perfect. I purchased the other barrel inletting tools in anticapation of problems...don't bother...just buy the scraper...in fact buy them both ...large and small. I only purchased the small ...I could have used the large in the swamped barrel but I managed to do fine. I do not have a financial interest in this company , but I wish I did. I hope this may be beneficial to you in your inletting. Bill
Vi opplevde en feil under innlasting av dette innholdet. Vennligst last inn siden på nytt for å fortsette. Hvis problemet vedvarer, ta kontakt med kundeservice.