EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. Does not work with M&P, M&P 2.0 or M&P 22.
Kompakt og pålitelig siktemontasje for Vortex Viper/Venom
EGW rødpunktsikter er laget for å bli installert fra venstre til høyre (med løpet vendt fremover). Dovetailen har en progressiv taper for enklere installasjon.
Følg disse trinnene for å montere din Vortex Viper/Venom, Burris FastFire, eller Docter rødpunktsikte:
- Fjern bak-siktet på våpenet ditt.
- Installer EGW Sight Mount i dovetailen.
- Stram settskruen (hvis aktuelt).
- Plasser rødpunktsiktet på EGW Sight Mount (å plassere et lite stykke papir mellom rødpunktsiktet og siktemontasjen vil gjøre fjerning enklere og holde Loctite unna rødpunktsiktet).
- Påfør blå Loctite på de medfølgende monteringsskruene.
- Dra til monteringsskruene til 15 in/lbs.
Inkludert monteringsutstyr:
- 2 Button Head Cap Screws - Til Vortex Viper og Venom Sights.
- 2 Flat Head Cap Screws - Til Burris FastFire og Docter Sights.
Skruene som følger med denne montasjen krever en 5/64'' allen-nøkkel for installasjon.
Viktig informasjon:
- Modifikasjon av våpenet ditt kan annullere produsentens garanti.
- Dette produktet bør installeres og kontrolleres av en kvalifisert våpensmed.
- Ingen ansvar er uttrykt eller antydet for skade eller skade som kan oppstå fra feil installasjon eller bruk av dette produktet.
- Fungerer ikke med M&P, M&P 2.0 eller M&P 22.