Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Trijicon RMR red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount does not fits: S&W M&P S&W M&P 2.0 S&W M&P 22
Oppgrader din S&W M&P SHIELD EZ med EGW Trijicon RMR Sight Mount!
Med EGW mount kan du enkelt montere din Trijicon RMR rødpunktsikte på din S&W M&P SHIELD EZ. Følg de enkle trinnene nedenfor for å erstatte din bakre sikte med EGW mount.
Produktbeskrivelse
- Fjern bakre sikte*
- Installer EGW Sight Mount i dovetail-sporet
- Stram settskruen (hvis aktuelt)
- Plasser rødpunktsiktet på EGW Sight Mount (plassering av et lite papir mellom rødpunktsiktet og sight mount vil gjøre fjerning lettere og hindre Loctite fra å komme på rødpunktsiktet.)
- Påfør blå Loctite på de medfølgende monteringsskruene
- Dra til monteringsskruene til 15in/lbs
De medfølgende skruene krever en 5/64'' allen-nøkkel for installasjon.
Vær oppmerksom på: Denne mount passer ikke til:
- S&W M&P
- S&W M&P 2.0
- S&W M&P 22