EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount yourVortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Please take note to the Pre 2017 and Post 2017 differences. Pre 2017 rear shelf behind the dovetail is .187"" and Post 2017 is .120".
Kraftig og pålitelig siktemontasje for Desert Eagle
EGW siktemontasje for Vortex Viper/Venom er designet for å gi en enkel og sikker installasjon på din Desert Eagle før 2017-modellen. Denne montasjen lar deg montere et red dot-sikte uten behov for modifikasjoner.
Produktbeskrivelse
EGW red dot-sikter skal installeres fra venstre til høyre (med løpet vendt fremover). Dovetailen har en progressiv taper for enklere installasjon. Følg disse trinnene for å montere ditt Vortex Viper/Venom, Burris FastFire, eller Docter red-dot-sikte:
- Fjern bakre sikte fra våpenet ditt.
- Installer EGW siktemontasje i dovetailen.
- Stram settskruen (hvis aktuelt).
- Plasser red dot-siktet på EGW siktemontasje (plassering av et lite papir mellom red dot-siktet og siktemontasjen vil gjøre fjerning enklere og holde Loctite borte fra red dot-siktet).
- Påfør blå Loctite på de medfølgende monteringsskruene.
- Dra til monteringsskruene til 15in/lbs.
Inkludert monteringsutstyr
- 2 Button Head Cap Screws - For Vortex Viper og Venom Sights
- 2 Flat Head Cap Screws - For Burris FastFire og Docter Sights
Skruene som følger med denne montasjen krever en 5/64'' allen-nøkkel for installasjon. Vær oppmerksom på forskjellene mellom Pre 2017 og Post 2017. Pre 2017 bakre hylle bak dovetailen er .187", mens Post 2017 er .120".