Attributes
- Modell:
Scorpion
- Våpentype:
CZ
- Leveringsvekt: 0,045kg
- Frakthøyde: 20mm
- Fraktbredde: 71mm
- Fraktlengde: 137mm
- UPC: 856008005888
Elementdetaljer
US eksport klassifisering: 0A501.x
Scorpion
CZ
Produktnr.: 100023383
Produsentnr.: 116-106
856008005888 Apex Low Profile Safety Lever Set for CZ Scorpion EVO 3 S1 passer både til pistolen og karbinen, og er kompatibel med CZs sammenleggbare kolbe. Sikkerhetsheisene er laget av 6061 aluminium, hardcoat anodisert svart, med en maskinert indikatorslinje. Krever 1,5 mm unbrakonøkkel for installasjon. Direkte erstatning av fabrikkens sikkerhetsheis Maskinert indikatorslinje på hver heis Passer til CZ Scorpion EVO 3 S1 pistol og karbin Opprettholder fabrikkens sikkerhetsverdierLeveringstid ca. 14-21 dager.
Apex Low Profile Safety Lever Set for CZ Scorpion EVO 3 S1 passer både til pistolen og karabinen, og er kompatibel med CZ sammenleggbare stokk.
Oppgrader sikkerheten på din CZ Scorpion med Apex Low Profile Safety Lever Set, som gir både funksjonalitet og stil.
Scorpion
CZ
Nice, but needed fitting on my Scorpion 06.01.2018
No doubt the factory safety levers are terrible on the Scorpion. These low profile safety levers were part of my first round of mods to my Scorpion.
What should have been a 5 minute project expanded to over an hour because the Apex levers would not fully seat on the factory safety bar.
I had to sand the ID of the Apex levers to open them up a bit. I used some 220 grit sandpaper wrapped around a 1/4" drill bit. I did sneak up on it so the levers fit snug, so that may have taken more time than necessary.
After install, I immediately installed a new grip (also by Apex from Brownells), so I don't have a comparison of how they feel with the stock grip.
Overall, they are better than stock, but not sure it was truly worth the money and time.
Vi opplevde en feil under innlasting av dette innholdet. Vennligst last inn siden på nytt for å fortsette. Hvis problemet vedvarer, ta kontakt med kundeservice.