Attributes
- Modell:
Commander
,Government
- Våpentype:
1911
- Leveringsvekt: 0,014kg
- Fraktbredde: 83mm
- Fraktlengde: 146mm
Produktnr.: 168000127
Produsentnr.: P28SC
Komplett sett med 11 presisjonsbearbeidede pinner og plunger for oppussing av en eksisterende 1911 eller for å bygge en ny fra bunnen av. Herdet for utmerket motstand mot overflateslitasje for lang levetid. Tilgjengelig i matt blånerte karbonstål eller rustfritt stål med naturlig finish.Leveringstid ca. 14-21 dager.
1911 PIN SET fra CASPIAN er den perfekte løsningen for både oppussing av en eksisterende 1911 og bygging av en ny fra bunnen av. Dette settet inkluderer alle 11 presisjonsbearbeidede pinner og plunger som er nødvendige for en grundig oppgradering.
Settet er varmebehandlet for å gi enestående motstand mot overflateslitasje, noe som gir en lang levetid. Du kan velge mellom matte blued karbonstål eller naturlig finish rustfritt stål.
Passer til 1911 Government Model, Commander og kloner; passer ikke til Officers-modellen.
Commander,
Government
1911
Buyer Beware 27.12.2011
I bought this set of pins to finish out a 1911 build I'm doing for my wife. I ordered the Caspian Race Ready Receiver (168-100-110) for the build, so I figured I'd order this pin set since it's made by the same manufacturer. The ejector pin in this set is solid, and I think it's slightly oversize, as it bent while I was trying to install it into the ejector pin hole (yes, I had done the requisite notching of the ejector post, and there was no blocking of the hole when I looked thru it; I also should have measured the diameter of the pin against the diameter of the hole--I really think a roll pin is better for this application).
Additionally, if you decide to use the Cylinder and Slide Professional Trigger Kit (206-000-019), the hammer strut pin in this set is too large (the pin is .095 and the hole in the hammer is about .093). I reamed out the hole in the hammer, but it was still a very hard pin to drive in.
In the future, I will probably order a different set of pins. I may or may not order Caspian pins again, I haven't yet decided. The mainspring parts are all fine, as are the plunger pins and the sear and hammer pins.
I want to caveat the "Would you recommend this to a friend" question by saying I would recommend it, but I would also tell them what I experienced.
Vi opplevde en feil under innlasting av dette innholdet. Vennligst last inn siden på nytt for å fortsette. Hvis problemet vedvarer, ta kontakt med kundeservice.