Din handlekurv er tom.

Handlekurv

37 17 00 00

Meld på nyhetsbrev

APEX TACTICAL SPECIALTIES INC
TACTICAL POLYMER SD ACTION ENHANCEMENT TRIGGER

856008005352 100013547

The Apex Polymer Action Enhancement Trigger Kit directly replaces the factory hinged trigger with a solid body polymer trigger with a center mounted pivoting safety. The rounded face of the trigger provides a smooth, comfortable surface for the shooter’s finger while firing. The trigger also reduces pre-travel by approximately 20% and over travel by 10% when compared to the factory trigger and is perfect for use in SD and Sigma pistols. The reduced power trigger spring kits can be special ordered. Use item 000-002-152 for Sigma.

Mer...

Apex Polymer Action Enhancement Trigger Kit erstatter direkte den fabrikkmonterte hengslede avtrekkeren med en solid kroppspolymeravtrekker med en sentrert, pivoterende sikkerhetsmekanisme. Den avrundede overflaten på avtrekkeren gir en jevn, komfortabel overflate for skytterens finger under avfyring. Avtrekkeren reduserer også forhåndsreisen med omtrent 20% og overstyringen med 10% sammenlignet med fabrikkavtrekkeren og er perfekt for bruk i SD- og Sigma-pistoler. Redusert kraft avtrekkerfjærsett kan spesialbestilles. Bruk varenummer 000-002-152 for Sigma.

Mer...

Kundevurderinger for APEX TACTICAL SPECIALTIES INC APEX POLYMER ACTION ENHANCEMENT TRIGGER

Antall vurderinger: 5
Fra brownells.com: 5
Gjennomsnittsvurdering: 4,2

Significant fitting needed for SD9VE (29.09.2014)

Installed with much effort on an SD9VE. As a "direct replacement," the trigger fit fine, but would not pull the striker rearward enough to allow the pistol to fire. Significant material needed to be removed from the wide "V" at the rear of the trigger to provide enough travel to finally get it to work.

Pros: polymer is easily filed to make the fitting go faster, trigger design feels much more substantial than the stock trigger, results in noticeably shorter travel. If you fit this part in small iterations, you can get a trigger with virtually zero over-travel.

Cons: Needs quite a lot of fitting and it's best to remove the trigger each time to file it. (A file with a dead edge is HIGHLY recommended.) Also, the safety lever in the trigger did not pivot and retract quite enough, so it "clicked" on the frame with each trigger pull. Overpriced for the amount of effort required to get it to work.

Installation is a "project," but if you like your pistol, this allows for some quality bonding time.

Fitting Required (07.11.2014)

I had a fair amount of fitting to do but, after it was all said and done, it worked out nicely. I installed this on an SW9VE Sigma. It required some filing on the back side where the trigger stops on the frame. It made contact with the frame to soon and the connector bar would not drop off the sear to let the striker forward to fire. Secondly, I had to file where the front of the trigger meets the frame. It would not come forward far enough to allow the connector bar to reset onto the sear.

Now that it is done it feel much better that the original.

Easy (04.07.2015)

Dropped right into my SW9F. Much better than the stock trigger, noticeably shorter travel.

Cures SD VE trigger pull (07.04.2017)

Coupled with Apex' spring kit, this trigger turns one of the world's worst factory trigger pulls into something manageable. Trigger is now predictable, controllable thru the trigger stroke and the front sight stays aligned on target. Mine dropped in with no fitting required. Time to install was less than 20 minutes.

If you own a SD VE S&W, you need this kit.

FOR 1911 SHOOTERS (07.11.2017)

REQUIRES PATIENCE WITH A FILE. APEX TRIGGER WOULD NOT PERMIT MY SD9 VE TO FIRE WITHOUT FITTING. REAR OF TRIGGER CONTACTED PISTOL FRAME BEFORE STRIKER WOULD RELEASE. THE GOOD PART OF THIS IS THAT WHERE MATERIAL MUST BE REMOVED FROM TRIGGER TO FIRE PISTOL CONTROLS OVER TRAVEL. TOOK ME ABOUT 25 TO 30 MINUTES WITH FINE CUT SAFE EDGE FILE. ZERO OVER TRAVEL LIKE A 1911 WITH SHORT RESET FOR STRIKER FIRED PISTOL. 5 STARS IF IT WAS METAL. NOW IF THERE WAS 2 1/2 TO 3 LB SPRING KIT I MIGHT GIVE UP GOVT MODELS. .

Les 5 flere anmeldelser fra brownells.com

1099 1099 1 NOK

Produktnr.: 100013547
APEX TACTICAL SPECIALTIES INC APEX POLYMER ACTION ENHANCEMENT TRIGGER
Produsentnr.: 107-003 856008005352 Apex Polymer Action Enhancement Trigger Kit erstatter direkte den fabrikkmonterte hengslede avtrekkeren med en solid kroppspolymeravtrekker med en sentrert, pivoterende sikkerhetsmekanisme. Den avrundede overflaten på avtrekkeren gir en jevn, komfortabel overflate for skytterens finger under avfyring. Avtrekkeren reduserer også forhåndsreisen med omtrent 20% og overstyringen med 10% sammenlignet med fabrikkavtrekkeren og er perfekt for bruk i SD- og Sigma-pistoler. Redusert kraft avtrekkerfjærsett kan spesialbestilles. Bruk varenummer 000-002-152 for Sigma.

1099 NOK 2 kr 1 099,00 *

Leveringstid ca. 14-21 dager.
2 stk. på lageret i USA

Spesifikasjoner: Finish: Black Make: Smith & Wesson Modell: Sigma Style: Factory Replacement

Legg til ønskeliste

Still spørsmål

Detaljer

Legg til ønskeliste

Still spørsmål

Attributes

Finish: Black Make: Smith & Wesson Modell: Sigma Style: Factory Replacement Leveringsvekt: 0,005kg Frakthøyde: 14mm Fraktbredde: 70mm Fraktlengde: 116mm

Elementdetaljer

Made in USA
US eksport klassifisering: 0A501.c

Mer...

Kundevurderinger for APEX TACTICAL SPECIALTIES INC APEX POLYMER ACTION ENHANCEMENT TRIGGER

Antall vurderinger: 5
Fra brownells.com: 5
Gjennomsnittsvurdering: 4,2

Significant fitting needed for SD9VE (29.09.2014)

Fitting Required (07.11.2014)

Easy (04.07.2015)

Dropped right into my SW9F. Much better than the stock trigger, noticeably shorter travel.

Cures SD VE trigger pull (07.04.2017)

FOR 1911 SHOOTERS (07.11.2017)

Les 5 flere anmeldelser fra brownells.com

Logg inn

Glemt passord?
Registrere

CONNECT

NETTSTEDSKART

PRODUKTKATEGORIER

BESTILLING

KUNDE SERVICE

Velkommen!

Velkommen til Brownells.no, Norges ledende leverandør av våpenrelaterte produkter, våpendeler, børsemakerverktøy, ladeverktøy, ladeutstyr og ladekomponenter!

Vårt kundeløfte:

Uansett om du bare liker å skyte, har våpen som hobby, er børsemaker og reparerer våpen daglig eller bare eier et våpen er dette siden for deg! I over 75 år har skyttere, profesjonelle børsemakere, hobby utøvere, militæret, politiet og våpenreparatører kommet til Brownells for å finne produkter og deler av høy kvalitet. Hos oss finner du over 40 000 produkter inkludert unike våpendeler, tilbehør, børsemakerverktøy, ladeverktøy, ladeutstyr, komponenter, ammunisjon og andre produkter for å vedlikeholde, reparere eller oppgradere dine våpen.