EGW recommends measuring the hole spacing in your receiver to confirm it matches with the dimensions they have published. Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. EGW one-piece scope mounts are the obvious choice for hunters and tactical shooters alike. They machine these in their shop using one of their machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability. Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is sold separately).
EGW anbefaler å måle hullets avstand i mottakeren for å bekrefte at det stemmer med de publiserte dimensjonene. Picatinny-tverspor går over hele skinnens lengde, noe som gir skytteren fleksibilitet når det gjelder montering av kikkertsikteringer og andre tilbehør. Kanalen i midten reduserer den totale massen av festet. I mange tilfeller vil det heller ikke hindre bruk av fabrikkens jernsikter. EGW sine enhetlige siktefester er det opplagte valget for jegere og taktiske skyttere. De maskinerer disse i deres verksted ved hjelp av et av deres maskineringssentre. Etter maskinering blir festene tumblerbehandlet, sandblåst og Type II anodisert for langvarig holdbarhet. Installasjon: EGW anbefaler 20 tommer pund med dreiemoment og en dråpe blå loctite (loctite selges separat).