Attributes
- Modell: 1200,1300,500,870,88
- Våpentype: Maverick,Mossberg,Remington,Winchester
- Leveringsvekt: 0,249kg
- Frakthøyde: 30mm
- Fraktbredde: 51mm
- Fraktlengde: 467mm
- UPC: 758152513007
Produktnr.: 019000004
Produsentnr.: SHS1300
758152513007 Leveres med et komplett sett av adaptere og mellomstykker for montering på 12 gauge Mossberg 500, Maverick 88, Remington 870, og Winchester 1200/1300 pumpehagler. Enkel å installere, krever ingen modifikasjoner av våpenet. Formet stål med forlengede kjølespor beskytter hendene dine mot brannskader. Gir en sikker, sklisikker gripeflate, pluss maksimal varmespredning. Bare skyv over løpet og fest med medfølgende hardware. Svart oksid finish matcher de fleste hagle-finishene. Ingen gunsmithing er nødvendig for å passe de mest populære 12 gauge pumpevåpnene.
Gratis frakt fra kr 2 990.
Leveringstid ca. 14-21 dager.
SPECS: Stål, svart oksid, matt finish. 13¾ (35cm) lang.
A good buy 25.01.2014
This was an easy install, it is not a custom piece built specific to any gun, it is built to fit every 870 ever made. Take your time and you won't damage the finish on your weapon or on the heat shield. The instructions are pretty clear and easily followed (I read them afterwards) no modification was required to my weapon (H&R Pardner Protector Pump) even though I installed an 870 wood stock and forearm and a +2 magazine extension. The heat shield does require a little patience for a good tight fit but looks good after installation. It is a great deal for quality and looks, especially because it it metal and cost the same as some synthetic models
1300 defender 05.03.2012
*this may not apply to all shotguns* The fit and finish of the product is unacceptable. During install the heat shield heavily scratches the barrel's finish. The receiver end of the shield does not grip the barrel well allowing it to move and produce wear on the barrel. The forward end, with the two screw holes, comes to you flared out and out of alignment. This neccesitates a lot of test fits and alterations which again damages the finish of the gun. A gunsmith might have better luck with it. Mine found its way into the dumpster.
Vi opplevde en feil under innlasting av dette innholdet. Vennligst last inn siden på nytt for å fortsette. Hvis problemet vedvarer, ta kontakt med kundeservice.