Attributes
- Leveringsvekt: 0,045kg
- Frakthøyde: 1mm
- Fraktbredde: 140mm
- Fraktlengde: 152mm
Produktnr.: 713000098
Produsentnr.: NONE
Et enkelt å bruke system som justerer avtrekkeren med bunnen av metallet for en profesjonell beddingjobb uten å skade de originale skruene. Polymerbushinger, to på hver stift, tetter de gjengede avtrekkerskruene og bunnen av metallinnløpene for å holde epoxyoverskudd ute og bidra til å forhindre at deler blir permanent bundet i stokken.Leveringstid ca. 14-21 dager.
Med BOLT ACTION RIFLE BEDDING STUDS fra POWER CUSTOM kan du enkelt oppnå en profesjonell beddingjobb. Dette brukervennlige systemet justerer aksjonen med bunnmetallet uten å skade de originale skruene.
Polymerbushinger, to på hver stud, tetter de gjengede akseskruhullene og bunnmetallet for å hindre at epoxy renner over og for å forhindre at deler blir permanent bundet i stokken.
Makes pillar bedding a lot easier 27.08.2012
I used these bedding studs on my Yugo Mauser with third party stock. They screw right into the front and rear no problem. Then slide the pillars on and apply epoxy. Put them down through the floorplate and slide on the white spacers. Screw them down and you have pillars lined up perfectly with your action. If your studs get stuck in the pillars because you didn't use enough release agent, you put the second nut against the first to create a lock and wrench the stud out...No wear and tear on your action screws. I wish they made them in more action thread sizes for different rifles.
Simply Outstanding 28.09.2011
Kit comes with two shouldered, threaded rods that are smooth below the shoulder about halfway down to eliminate stuck action screws and needing to ream bedding compound from bolt holes. Producing perfect, stress-free bedding jobs require nothing more than filling holes with modeling clay, spraying brownells release agent on the action and studs, and gently tightening the action into the stock with bedding compound while observing the barrel channel vs barrel. No cleaning of action screw threads, and the studs pop right out when the work is done courtesy of the threads on the bottom of the studs.
Vi opplevde en feil under innlasting av dette innholdet. Vennligst last inn siden på nytt for å fortsette. Hvis problemet vedvarer, ta kontakt med kundeservice.