Attributes
- Leveringsvekt: 0,567kg
- Frakthøyde: 91mm
- Fraktbredde: 94mm
- Fraktlengde: 277mm
- UPC: 757253718014
Produktnr.: 749007261
Produsentnr.: 010482
757253718014 Nøyaktig ytelse fra ammunisjonen din er helt avhengig av ensartethet både i prosjektilet og hylsen. Å oppnå denne ensartetheten er ikke mulig uten en nøyaktig, pålitelig måleinstrument. Forster sin eksklusive Co-Ax Case & Cartridge Inspector gir deg muligheten til å sikre ensartethet ved å måle tre kritiske dimensjoner: tykkelse på nakkevegg, konsentrisitet av hylsen, og prosjektilets avvik. Målingene er i intervaller på en tusendel av en tomme, så nøyaktigheten er strålende. Inspektøren er unik fordi den sjekker både prosjektilets og hylsens justering i forhold til senterlinjen (aksen) til hele patronen eller hylsen. Forster Case Inspector bruker Forster Case Trimmer Pilots (selges separat).Leveringstid ca. 14-21 dager.
For å sikre presisjon i ammunisjonen din, er det avgjørende å ha enhetlighet både i prosjektilet og hylsen. Med Forster CO-AX® CASE AND CARTRIDGE INSPECTOR får du et pålitelig måleinstrument for å oppnå denne enhetligheten.
Forster Co-Ax Case & Cartridge Inspector gir deg muligheten til å måle tre viktige dimensjoner:
Målingene skjer i intervaller på en tusendels tomme, noe som gir enestående nøyaktighet. Inspektøren er unik fordi den sjekker både prosjektilets og hylsens justering i forhold til senterlinjen (aksen) til hele patronen eller hylsen.
Forster Case Inspector bruker Forster Case Trimmer Pilots (selges separat) for optimal ytelse.
Useful 11.09.2017
I agree with the above review about the difficulty of set up and the V groove. The tool is tedious to setup, and when you change over from checking concentricity to checking T.I.R. it again takes time to get all the adjustments made. It isn't the most efficient process and the tool really can't handle a long cartridge witout the case head compression spring pushing the meplat into the adjustment bar, though it is very useful for checking case neck thickness. I'm not a competitive shooter where I need every little bit of accuracy, but I do like to build very consistent rounds. Knowing what I do now I would have purchased the Sinclair concentricity guage instead
So so tool 28.09.2013
The v groove holder the bullet sits in was very rough from the factory. So much so that within a few turns it was cutting the copper on the bullet. little time with a dremmel and a stone and polish wheel cleaned it up glass smooth and the problem is gone. It takes a little bit to get the tool setup right so all the angles jive but once done it seems to work pretty well. One thing to note though is if the meplat is not perfect you will not get a good measurement. There is a spring that pushes the round against an anvil where the v groove piece above is. This causes the round to wobble a little giving inaccurate measurements if you are not careful. Need to put a little sizing wax on the rear v section where the case rolls to make it smooth.
Overall it works well once you take the time to properly adjust everything but is definitely not a tool for the impatient!
Vi opplevde en feil under innlasting av dette innholdet. Vennligst last inn siden på nytt for å fortsette. Hvis problemet vedvarer, ta kontakt med kundeservice.